Hey guys
I've built a 4m x 3m studio, which is effectively a sound insulated room built within a shed. I'd like to change the setout so my two amp heads are located at the other end of the room to the cab they drive (I switch betwen heads using a Radial HeadBone).
A couple of questions on this:
- Am I going to be losing anything tone-wise by having a 5m run of speaker cable between my amps (both 1W monsters!) and cab?
- If I was to install speaker jack terminals at either end of the room, and run speaker cable under the flooring, would wall plates with standard 1/4" TRS jacks be suitable, or would I need specialised jacks to handle the higher voltages of an amp (ie. much higher than instrument level)?
Thanks in advance!