new & improved JMP-1 rack pre ideas

Marshall amplifiers not listed above. AVT, MG, Valvestate, Rack gear

Moderator: longfxukxnhair


Blues_N_Cues
Knighted
Knighted
User avatar
Posts: 3680
Joined: 01 Mar 2013, 05:54
Location: near Nashville
Has Liked: 2033 times
Been liked: 1176 times
Contact:

new & improved JMP-1 rack pre ideas

Postby Blues_N_Cues » 19 Dec 2013, 01:39

keep the 26 factory presets but add 4 to even it out to 30.-
that tophat dude Appetite tone
Joe Bonamassa tone
Yngwie &/or Satch tones
or @ least something like toneprinting(more on that below) like other companies are now doing.
usb connectivity & software for toneprint downloading/settings upload sharing plus direct record out as a vsti type device.

the ability to roll back vol to clean up,personally I do this to an extent but the Billy Gibbons rig run down disagrees. :dunno

a separate phones out volume control so you don't have to jack w/ your presets volumes. :Thumbs

LABEL left preamp out as a mono out.lol

get rid of that inherent hum wherever it comes from.

for the battery,install a clip type holder.they can't be that expensive when done in bulk
and while yer @ it change the battery size to a standard COSM 2032.

since it will most likely be made in Vitnam,China,etc. keep the price point low.

oh yeah,a little more detail in the owner's manual.
keeping it loud- JMP-1 rack,LPs,strats,& way too much other gear.
my sounds,songs,& snippets-
https://soundcloud.com/rlc-ltd
http://www.reverbnation.com/rlcltd

Return to “Marshall General Discussion”

Who is online

Users browsing this forum: No registered users and 26 guests